Module description
...
This status message is generated and sent cyclically. The details of the sent message and its cycling are determined in the configuration.
...
CONNEXION LOSS status point
In case of a loss of connection with the RTU, the idea is to inform the Center that the connection has been lost. This information is sent as follows:
...
Since this information is configured as fugitive, it is not necessary to reset the piloting to 0.
Configuration
...
ACCESS status point
...
The configuration of a status point cyclic is present in the Exchanged_data configuration.
An attribute called "ts_syst_cycle" is added to allow the configuration of a status point as cyclic.
Example :
| Code Block | ||
|---|---|---|
| ||
{
"label" :"GAMBS_0_TS-SYST_ACCES",
"pivot_id" :"xxx",
"pivot_type" :"SpsTyp",
"pivot_subtypes" : ["acces"],
"ts_syst_cycle" :30
"protocols" :[
{
"name" :"hnzip",
"typeid":"yyy",
"address":"zzz"
}
]
} |
...
CONNEXION LOSS status point
The configuration of the status point in Exchanged_data includes the subtype of the status point. To configure a status point as PRT.INFO, the pivot_subtypes attribute is set to prt.inf.
| Code Block | ||
|---|---|---|
| ||
{
"label" :"GAMBS_0_TS-SYST_ACCES",
"pivot_id" :"xxx",
"pivot_type" :"SpsTyp",
"pivot_subtypes" : ["prt.inf"],
"protocols" :[
{
"name" :"hnzip",
"typeid":"yyy",
"address":"zzz"
}
]
} |
...
- "asset" is the name of the status transmission asset.
Filtering rules
...
ACCESS status point
...
The readings are transmitted without verification any check or modification.
...
CONNEXION LOSS status point
The readings are transmitted without verification any check or modification.
Data processing
...
ACCESS status point
...
Input
The cycling of the status point is not conditioned by the reception of data by the module.
Ouput
For each status point configured to be sent cyclically, the generated data is as follows:
...
The type of the status point is read directly from the exchanged_data configuration.
...
CONNEXION LOSS status point
Input
The plugin listens to the status reading of the associated South service.
If the "connx_status" is in the "not connected" state, the plugin must generate a status point configured with the value 0.
If the "gi_status" is in the "finished" state, the plugin must generate a status piont configured with the value 1.
Output
The plugin generates the status point in its output as follows:
...